NordicTrack NTC59020 Carefully pull, Slide, Upright onto the Frame, This step, Upper Wire Harness

Page 5

2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).

2

1

16

55

5554

54

3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (42) to

the Lower Wire Harness (43).

 

Carefully pull the

upper end of the Upper Wire Harness to remove

 

the slack from the Wire Harnesses.

 

 

Make sure that the Upright (2) is turned so the top

slopes down in the direction shown.

 

Slide the

Upright onto the Frame (1).

Be careful to avoid pinch-

ing the Wire Harnesses (42, 43).

Attach the Upright to

the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).

3

Top must slope down in this direction.

2

55

54

55

1

Do not pinch the Wire Harnesses (42, 43) during

this step.

55

54

42

43

4.Hold the Handlebar (3) near the Upright (2). Feed the Upper Wire Harness (42) up through the indicated hole in the Handlebar. Attach the Handlebar to the Upright with two M8 x 25mm Patch Screws (59) and two M8 Split Washers (55). Be careful to avoid pinching the

Upper Wire Harness.

4

Do not pinch

 

 

the Upper

 

Wire Harness

 

(42) during

59

this step.

55

Hole

 

3

42

2

5

Image 5
Contents Customer HOT Line QUESTIONS?Important Precautions Table of ContentsRight Side Before YOU BeginYou use the exercise cycle Assembly requires two persons AssemblyCarefully pull Upper Wire HarnessSlide Upright onto the FrameDo not pinch Wires during This step On the Console. Next, locate the two pulse wiresGround Wires Pulse Have another person hold the Console 4 near the HandlebarInstalling the Receiver for the Optional Chest Pulse Sensor HOW to Adjust the Seat Post HOW to Move and Level the Exercise CycleHOW to Adjust the Seat Features of the Console Console DiagramLeft Display Matrix Cassettes areSelect the manual mode HOW to USE the Manual ModeBegin pedaling to activate the console Generator as you pedal.To activate the conThin sheets Measure your heart rate if desiredPlastic on PlasticSelect one of the six resistance and pace Programs HOW to USE Resistance and Pace ProgramsRight LeftMonitor your progress with the two displays HOW to USE Heart Rate ProgramsSelect one of the heart rate programs 3Enter your ageColumn to the left Hold the handgrip pulse sensorPedaling to start the program HOW to Connect Your Portable Stereo HOW to Connect Your CD PLAYER, VCR Or ComputerLine OUT jack Phones jack, see instruction BAudio Cable Adapter Adapter HOW to Connect Your VCRAdapter Audio Cable To pur Pace setting is about to changeFree Video programFollow the on-line instructions to start Program HOW to USE Programs Directly from OUR WEB SiteReturn to the exercise cycle and begin Pedaling Chest pulse sensor, call toll-freePulse Sensor Troubleshooting HOW to Adjust the Reed SwitchHOW to Adjust the Drive Belt Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyQty Description Key No. Qty Part LIST-Model No. NTC590203968 R1102APart No R1102A HOW to Order Replacement PartsLimited Warranty
Related manuals
Manual 24 pages 11.24 Kb