b. Roughen the surface of the resistance pad with
c. Oil the 3/8” washers and the thrust washer if needed.
PROBLEM: The flywheel and/or the resistance strap offers no resistance.
SOLUTION: a. Check the routing of the resistance strap.
b. Make sure the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9). Evenly tighten the two 1/4” nuts located on the right side of the flywheel.
PROBLEM: The skis are slipping.
SOLUTION: a. Wipe off any excess oil.
b.Clean the bottom of the skis with a dry cloth or a small amount of mineral spirits or paint thinner.
c.Make sure that the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9). Evenly tighten the two 1/4” nuts located on the right side of the flywheel.
PROBLEM: The rollers are squeaking or sticking.
SOLUTION:
12