NordicTrack NTBE01490 manual Assembly

Assembly

¥Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

¥Tighten all parts as you assemble them, unless instructed to do otherwise. For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.

¥As you assemble the weight bench, make sure that all parts are turned as shown in the drawings.

¥Assembly requires:

two adjustable wrenches a rubber mallet

a standard screwdriver a phillips screwdriver lubricant, such as grease or petroleum jelly.

Assembly may be more convenient with a socket set or a set of open-end or closed-end wrenches.

1.Press a 50mm Square Outer Cap (11) onto each end of the Small Stabilizer (14).

Attach the Small Stabilizer (14) to the Front Leg (12) with two M10 x 65mm Carriage Bolts (21) and two M10 Nylon Locknuts (6). Note: There is an indenta- tion around the holes on one side of the Small Stabilizer. This side must be facing the floor.

2.Press a 50mm x 70mm Outer Cap (5) onto each end of the Large Stabilizer (15).

Turn the Large Stabilizer (15) so the warning decal is in the position shown. Attach the Large Stabilizer (15) to the Bench Frame (3) with two M10 x 65mm Carriage Bolts (21) and two M10 Nylon Locknuts (6).

Note: There is an indentation around the holes on one side of the Large Stabilizer. This side must be facing the floor.

3.Attach the Front Leg (12) to the Bench Frame (3) with two M10 x 70mm Bolts (23), a Support Plate (10), and two M10 Nylon Locknuts (6).

1
		12
11	6
		14
	21	11
2
3		6
	5	Decal
		15
		21
		5
3
		6
10
		3
23		6
		12

6