15.Press two 48mm Round Inner Caps (23) into two Storage Tubes (12). Screw the Storage Tubes onto the Left Rear Upright (4). Make sure the
Storage Tubes are fully tightened.
Repeat this step with the other two Storage Tubes (12) and the Right Rear Upright (not shown).
16.Press two 32mm Round Inner Caps (25) into the end of the Left Weight Rest (19) and the Left Safety Spotter (17).
Insert the Left Weight Rest (19) and the Left Safety Spotter (17) into holes in the left Front Upright (6) and engage the locking pins around the Upright.
Repeat this step with the Right Weight Rest (not shown), the Right Safety Spotter (not shown), and the right Front Upright (not shown).
17.Wet the ends of the Lat Bar (43) and the Row Bar (47) with soapy water. Slide four Handgrips (44) onto the ends of the two Bars.
18.Make sure that all parts are properly tightened before you use the weight rack. The use of all remaining parts will be explained in ADJUST- MENTS starting on the next page.
15 |
|
|
|
| 12 |
| 4 | 23 |
|
| |
|
| 12 |
|
| 23 |
16 |
|
|
| 25 |
|
| 19 |
|
|
| 6 |
17 | 25 |
|
|
| |
17 |
|
|
44 |
|
|
| 43 |
|
44 |
|
|
| 47 |
|
| 44 | 44 |
|
|
10