3.Press a 60mm Square Inner Cap (22) into the Lat Tower (8).
Orient the Weight Carriage (10) as shown and slide it onto the Lat Tower (8). Orient the Carriage Stop (21) as shown and slide it onto the Lat Tower below the Weight Carriage.
Slide the Lat Tower (8) onto the Lat Tower Base
(3). Attach the Carriage Stop (21) at the indicated hole with an M10 x 86mm Bolt (35) and an M10 Nylon Locknut (32).
attach the Lat Tower (8) to the Lat Tower Base (3) with three M10 x 72mm Bolts (39), three M10 Washers (33), and three M10 Nylon Locknuts (32). Do not tighten the Locknuts yet.
4.Attach the Top Crossbar (9) to the Left Rear Upright (4) with two M10 x 94mm Bolts (34), two M10 Washers (33), and two M10 Nylon Locknuts (32). Do not tighten the Locknuts yet.
Attach the Top Crossbar (9) to the Right Rear Upright (not shown) in the same manner.
3 |
|
8 | Attach the |
Carriage Stop | |
22 | (52) here. |
| |
39 | 32 |
| |
33 | 32 |
| |
39 |
|
32 | 10 |
| |
| 21 |
| 35 |
| 3 |
4 |
|
| 4 |
34 |
|
9 |
|
34 | 33 |
| |
| 32 |
6