Repeat this step with the Right Link Arm

9.Apply a small amount of grease to the axle on the Left Link Arm (30), to the axle on the Left Pedal Arm (32), and to a Wave Washer (100).

Slide the Wave Washer (100) onto the axle on the Left Pedal Arm (32). Next, slide a Link Arm Spacer (74) onto the axle on the Left Link Arm (30).

Then, insert the axle on the Left Link Arm (30) into the left Upper Body Leg (24) while sliding the Left Link Arm onto the axle on the Left Pedal Arm (32).

Repeat this step with the Right Link Arm (31).

10.Attach the Left Link Arm (30) to the Left Pedal Arm (32) with an M8 x 15mm Button Screw (106), an M8.5 x 16mm x 1.5mm Washer (103), and an Axle Cover (66).

Attach the Left Link Arm (30) to the left Upper Body Leg (24) with an M8 x 25mm Button Screw (110), two M8.5 x 16mm x 1.5mm Washers (103), two Axle Covers (66), a Link Arm Spacer (74), and an M8 x 15mm Button Screw (106) as shown.

Attach the Right Link Arm (31) in the same way.

11.The Console (11) can be operated with four 1.5V “D” batteries (not included); alkaline batter- ies are recommended. Locate the two battery covers on the back of the Console. Press the tabs on the battery covers, and remove the bat- tery covers. Next, insert two batteries into each battery compartment; make sure that the bat- teries are oriented as shown by the symbols inside the battery compartments. Then, reat- tach the battery covers.

The Console (11) can also be operated with a regulated 6-volt DC 2-amp power supply (not included). To purchase a power supply, call the toll-free telephone number on the front cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power supply. Plug one end of the power sup- ply into the jack on the elliptical exerciser; plug the other end into an outlet installed in accor- dance with all local codes and ordinances.

9	24
	24
			31
Grease	74
		100
	30		32
			32
		Grease
10	24
	24
			31
			106
66	74	103
66	74	66
103		66
103
110
		30
		106	66
		103	66
			32
11			Battery
			Battery
			Cover
	11
Battery
Cover

12.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.