NordicTrack NTL07707.2 HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 20

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and the frame and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. Never move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Latch Knob

Frame

Handrail

Wheel Base

20

Image 20
Contents QUESTIONS? Please do not ContactCall TOLL-FREE On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unplugged See the inset drawing. Tie the long tieBe careful not to pinch the Upright Wire Them several times do not fully tighten Bolts yetDo not fully fold the Frame yet Tighten the Nut the Wheel must turn freelyTor and try again. if the Connectors are Sole MAY be Damaged When Power is Turned onPinch the wires Not Connected PROPERLY, the CONPage Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired Measure your heart rate if desired Turn on the fan if desiredHOW to USE a Preset Workout Select one of the preset workoutsHOW to USE AN Ifit Card Insert an iFIT card and select a workoutHOW to Adjust the Cushioning System HOW to USE the Stereo Sound SystemInformation Mode HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR1107A Key No. Qty DescriptionQty Exploded Drawing A-Model No. NTL07707.2 Exploded Drawing B-Model No. NTL07707.2 Exploded Drawing C-Model No. NTL07707.2 Exploded Drawing D-Model No. NTL07707.2 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty