ParaBody 950 st manual Pec guid~, rod support 43 and the base 15 using

Page 25

STEP 2

A.Screw the threaded end of the leg cable (108) approximately 3/4" into the end of the selector shall (115) and figh'~en [am nut securely as shown.

B.If upon completion of assembly, the head plate (117) does not sit on top of the firs]' weight plate (67),

push the head plate down, insert the selector pin (72) and perform several repefifion;~ at the station. This will relax the cczble system and prevent the head plated from lifting up.

C.If after completing s'tep B. the head plate still does not sit on top of the first weight plate or if there rs excess slack in the cable system, adiust the threaded end of the cable accordingly and retighten the iam nuf.

_ Shroud Assembly Instructions

Use this procedure to assemble the shrouds of the ParaBody 950ST

Ao Securely assemble the pec station shroud (51)

the pec guid~, rod support (43) and the base (15) using

four 5/8 x

blaok

button head cap

screws (59),

(Nofe-" The pec

station

shroud has no

labels,)

25

Image 25
Contents SeriousSteel Page Ii!!1 STPacts List Frame Assembly Instructions Step Four3/8 × 2-3/,~bo~ts99 andfour3/8 washers78 Siep4 Step Slap Step Step B ~OTE Both CAP TIGHT~D ¯-14 See Note Page Cable Guide Step F & H Step Step Step StepI ~ep Step Pec guid~, rod support 43 and the base 15 using This Concludes the Assembly of the Parabody 950 ST GYM