ParaBody 950 st manual Four3/8 × 2-3/,~bo~ts99 andfour3/8 washers78

Step 3

A.Securely assemble the bearing housl.n,g (22) and the center, pulley bracket (36) to fine front upright (31) using two 1/2 x 4-1/2' bolts (90), four 1/2' washers (79), and two 1/2" nylock (82). (Note: Push bearing housing up as high as possible before tightening.)

B.Assemble the right, pee arm ,I4) and one pec cam (29) to the bearing housing (22) using

sleeve bearlng (77), two 3/4 flange bearings (66), one 1/2" washer (79), and ona 1/2" nylock (82). (Note: Securely tighten, then back nut off 1/4 turn to allow the pec arm to rotate freely.)

C.Assemble the left pec arm (5) and one pec cam (29) to the bearing housing (22) using 3/4" sleeve bearing (77), two 3/4" flange bearings (66), 1/2" washer (79), and on e 1/ 2" n ylock

nut (B2). (Note: Securely tighten, then back nut off 1/4 turn to allow the pec arm to rotate freely.)

D.

Securely assemble one 3/8" spring pin (62) to both the right pec arm (4) and the left pec arm

as shown.

E. Apply two 1" x 1" glides (60) to the bearing housing (22) where the pec cams (2!)) contact with the bearing housing as shown.

F. Securely attach one pec arm pad (46) to both the right pec arm (4) and left pec arm (5)

four3/8 × 2-3/,~"bo~ts(99) andfour3/8" washers(78).

7