Step | ParaBody 950 st guide

Leg Sfatlon Cable Assembly Instructions

Use this procedure to assemble the leg station cable of the PARABODYg50 ST

STEP 1

A.Route the "loop" end of the leg cable (108) into the rear slot of the leg welght star< base (18) behind the weight stack, and out through the slot near the leg station.

B.Securely attach th~,,"loop" end of the leg cable (108), to the cam on the leg curl/e>:fension (8),

using one 3/8 x bolt (97), two 3/8" washers (78), and one 3/8" nylock

C.Secure the leg cable (108) and one 3-1/2" pulley (111) to the pulley flat on the leg frame

using one 3/8 x 2-1/,¢" b,olt (119), one 2-3/B 'L' bracket (75), three 3/8" washer:, (7B), one

spacer (120), and one 3/8' nylock nut (B3). (Note: The leg cable should be ro,,te,:l underneath

short leg of the 'L' bracket and over the top of the pulley. Also the 'L' bracket shc, uld be posffioned af a 45 degree angle to function properly.)

g.Secure the leg ca,hie (108.) and two 3-1/2 !' pulleys (111) to the leg weight stack base (18) using two 3/8 x 2-3/4' bolts (9-9), four 3/8" flange spacers (74), and two 3/8" nylock nuts (B3). Loop cable under the pulley prior to inserting if into the slot.)

Secure the leg cable (108~ and one 3-1/2' pulley (111) fo

leg guide rod support (25) using one 3/8 x 2-3/4" bolt (99), two 3/8" flange spac..ers (74), and one 3/8" nylock nut (83). (Note: Loop the cable over the pulley prior to inserting it in the slot.)