ParaBody 867101 manual LAT Option Assembly Instructions

867101 LAT OPTION ASSEMBLY INSTRUCTIONS

Insert one (1) 1-3/4 IN. SQ. ENDCAPinto the from end of the LATBASE,and two (2) 2-1/2 IN. ENDCAPSinto each end of the FOOTBRACEonthe LATBASEas shown on drawing.

Attach two (2) 5-1/2 X 2-1/2 IN. NONSIGDSTRIPSto the FOOTBRACEonthe LAT.BASE shown on drawing.

SECURELYassemble one (1) 3/8 X 2-3/4 IN. BOLT,two (2) 3/8 IN. WASHERS,and one (1) 3/8 LOCKNUTto the second set of holes in the BASEof the UPRIGHTFRAMEas shown on drawing.

Removethe 2 IN. SQ. ENDCAPfrom the BASEof the UPRIGHTFRAMEand insert file LATBASE up to the BOLTas shown on drawing and secure it in place, using one (1) THUMBSCREW.

LOOSELYassemble the LATUPRIGI~T to the BASEof the UPRIGHTFRAMEas shown on drawing using one (1) 3/8 X 3 IN. BOLT,two (2) 3/8 IN. WASHERS,and one 3/8 IN. LOCI(NUT the OUTSI])EI]OLE, and one 3/8 X 3-1/4 IN. BOLT,three (3) 3/8 IN. WASHERS,and one 3/8 IN, LOCI( NUT for the INSIDE ]]OLE. (DO NOT TIGHTENTttE BOLT CONNECTIONSAT T]~IS

TIME)

Attach eight (8) CARRIAGEGUIDESto both ends of the CARRIAGEas shown in (DETAILA) using the following steps:

A.. Thoroughly clean all inside surfaces where the CARRIAGEGUIDESare to be attached.

Removethe paper bacldng from the CARRIAGEGUIDESand firrrdy apply fllem to all shown surfaces (8 pIaces)

7.Attach one (1) 1-1/4 SQ. IN. RUBBERBUMPERto the center of the CARRL&GESTOPon the CARRIAGEas shown on drawing.

4 04/15/97