Base | ParaBody 250101 instruction

3/8 X 2-3/4” 48
38	LOW	19
	HEIGHT	41
	42	41
	42
		29
	49 3/8 X
	1-3/4”
	41
	10
	8
		22
FIGURE 10

STEP 10

•Securely assemble the CALF BLOCK (10) to the BASE (8) using two 3/8 X 2-3/4” BOLTS (48), two 3/8” WASHERS (38), and two 3/8” LOCK NUTS (41) as shown in FIGURE 10. (Note: The CALF BLOCK can be assembled to either side of the

BASE.)

•Apply the 4 X 14” NON-SKID STRIP (22) to the outside of the CALF BLOCK (10) as shown in FIGURE 10.

•Assemble the SWIVEL PULLEY BRACKET (5) to the BASE (8) using one 1/2” LOW HEIGHT LOCK NUT (42) as shown in FIGURE 10. (Note: Tighten this connection enough to remove excess play yet al1owing SWIVEL PULLEY BRACKET to rotate freely.)

•Securely assemble one 3-1/2” PULLEY (19) to the SWIVEL PULLEY BRACKET (5) using one 3/8 X 1-3/4” BOLT (49) and one 3/8” LOCK NUT (41) as shown in FIGURE 10.

	1/2		1/2		1/2		1/2		1/2			1/2
0		1		2		3		4		5		6