ParaBody 250101 manual Guide Rods

STEP 2

•Insert two WEIGHT PLATE BUSHINGS (23) into the “PARABODY” side of each of the fifteen WEIGHT PLATES (58) as shown in FIGURE 2.

23

58

FIGURE 2

STEP 3						54
• Securely assemble the WEIGHT STACK SHAFT						16
	(21) to the HEAD PLATE (20) using one 3/8 X 1-
					20
	1/4” BOLT (44) and one 3/8” WASHER (38).
•	Insert two GUIDE RODS (16) into the BASE (8)
	as shown on FIGURE 3. (NOTE: Lubricate
	GUIDE RODS (16) with silicon or teflon spray				38	21
	available at most hardware stores.)
				44 3/8 X 1-1/4”
• Slide two WEIGHT STACK CUSHIONS (53)
	down over the GUIDE RODS (16).
•	Using EXTREME CARE slide all fifteen				58
	WEIGHT PLATES (58) down over the GUIDE
	RODS (16) on to the WEIGHT STACK CUSH-
	IONS (53). Make sure that the keyholes of the
	WEIGHT PLATES (58) are all facing the right
	way.			34		17
• Slide the head plate assembly down over the
	GUIDE RODS (16) onto the weight stack.
• Insert two CAP PLUGS (54) into the top of the					53
	GUIDE RODS (16).
• Attach the WEIGHT STACK LABELS (17) to the
	weight stack. Also insert the WEIGHT STACK
	SELECTOR PIN (34) into the first WEIGHT
	PLATE (58) of the weight stack.
					FIGURE 3			8
	1/2	1	1/2	1/2	1/2	1/2	5	1/2
	0		2		3	4		6
					5