Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two

included hex keys, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

Use the drawings below to identify the small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled.

M4 x 16mm M4 x 16mm Round

M8 Split

M8 x 18mm

Screw (89)–32 Head Screw (91)–6

Washer

M8 x 23mm

M8 x 25mm

Washer (93)–4

(85)–11

Washer (103)–2

Washer (119)–2

M8 x 13mm Button	M8 x 16mm Button	M8 x 20mm Button	M8 x 25mm Patch	M8 x 25mm Button
Screw (90)–8	Screw (94)–4	Screw (118)–2	Screw (123)–2	Screw (100)–1

M8 x 47mm Button Screw (110)–2

M8 x 65mm Button Screw (95)–8

Union Set (86)–2

1.Orient the Front Stabilizer (3) as shown. Attach the Front Stabilizer to the Frame (1) with four M8 x 65mm Button Screws (95) and four M8 Split Washers (85).

Next, attach the Front Shield (38) to the Front Stabilizer (3) with two M4 x 16mm Round Head Screws (91).

Then, tighten the two Frame Cushions (106) into the underside of the Frame (1).

1	91
	91
	38
	1
	3
		85
	85	106
	85	95
		95
	95