Reebok Fitness RBE0995.1 manual

2.	Orient the Rear Stabilizer (2) as shown. Attach the	2
	Rear Stabilizer to the Frame (1) with four M8 x 65mm
	Button Screws (95) and four M8 Split Washers (85).
			2
		1
			85
		85	95
		95
3.	Slide an M8 x 25mm Washer (119) onto an M8 x	3
	20mm Button Screw (118). Tighten the Button Screw
			Opening
	into one end of the Incline Axle (68). Apply a small
	amount of the included grease to the Incline Axle.	5
	Orient the Ramp (5) so the opening is in the position
	shown. Fit the welded tube on the underside of the		Welded
	Ramp between the two rings on the top of the Frame		Tube
	(1). Insert the Incline Axle (68) through the rings and		119	118
	the welded tube.
			Grease
	Slide an M8 x 25mm Washer (119) onto an M8 x		1
	20mm Button Screw (118). Tighten the Button Screw
	into the open end of the Incline Axle (68).		68
		119
		118
4. Using your fingers, turn the shaft on top of the Motor		4
	(46) counterclockwise until it stops turning. Next, fit the		1
		5
	opening of the Ramp (5) over the front of the Frame
	(1) as shown. Position the U-bracket on the underside
	of the Ramp over the end of the shaft as shown.		111
	Insert the Clevis Pin (112) through one side of the U-		65
	bracket on the Ramp (5), an 8mm Plastic Spacer	112
	(111), the shaft on the Motor (46), another 8mm Plastic
	Spacer, and the other side of the U-bracket. Then,		46
	insert the straight end of a Hairpin Cotter Pin (65)
	through the hole in the Clevis Pin.

5