10.Identify the Left Butterfly Arm (6) by the posi- tion of the long side of the indicated tube. Slide a Weight Stop (31) onto the Butterfly Arm.
Grease an M10 x 57mm Bolt (26). Attach the Left Butterfly Handle (7) to the Left Butterfly Arm (6) with the Bolt and an M10 Nylon Locknut (51). Do not overtighten the Locknut; the Handle must be able to pivot easily.
Repeat this step with the Right Butterfly Arm (not shown) and Right Butterfly Handle (not shown).
11.Grease an M10 x 138mm Bolt (45). Attach the Left Butterfly Arm (6) to the indicated Upright (4) with the Bolt and a Butterfly Knob (55).
Repeat this step with the Right Butterfly Arm (56).
12.Route the Cable (34) through the Lat Tower (9) and over the Pulley (36). Make sure that the Cable is under the lat rest bar. Attach the Pulley inside the Lat Tower with an M10 x 57mm Bolt (26), two M10 Washers (50), two 7.5mm Spacers (35), and an M10 Nylon Locknut (51).
13.Insert an M10 x 20mm Bolt (47) into the bracket on the Weight Carriage (10).
Slide the Weight Carriage (10) onto the Lat Tower
(9).Make sure the bracket on the Weight Carriage and the lat rest on the Lat Tower (see step 12) are on the opposite sides.
Attach the Cable (34) to the M10 x 20mm Bolt
(47)with an M10 Nylon Locknut (51).
10 |
|
|
6 |
|
|
| 7 |
|
Tube |
|
|
|
| 26 |
31 | 51 |
|
11 |
|
|
56 | 4 | 45 |
| ||
|
| Grease |
55 |
|
|
12 |
|
|
35 | 34 |
|
|
| |
51 |
|
|
50 | 35 |
|
| 26 | |
36 | 50 |
|
|
| |
| Lat |
|
| Rest |
|
9 |
|
|
13 | 9 |
|
|
| |
34 |
|
|
51 | 47 |
|
|
| |
Bracket | 10 |
|
|
| |
8