Reebok Fitness RBBE2057.0 manual Screws yet

Page 10

10.Apply a small amount of grease to an M10 x 95mm Button Bolt (73).

Pull the Long Adjustment Knob (37) out as far as it will go. Insert the bracket on the Backrest Frame (8) into the Top Cover (23). Next, attach the Backrest Frame to the Center Frame Extension (6) with the M10 x 95mm Button Bolt (73) and an M10 Nylon Locknut (65). Then, engage the Long Adjustment Knob into one of the holes in the bracket.

See the inset drawing. Attach an M8 x 16mm Button Bolt (61) and an M8 Nylon Locknut (72) to the hole in the end of the bracket on the Backrest Frame (8).

10

72

 

 

8

 

61

8

Bracket

23

 

65

37

 

 

6

Grease

73

 

11.See the left inset drawing. Identify the Top Tube (16), the Bottom Tube (17), and the Ankle Brace Tube (18); the Tubes have differ- ent lengths and holes in different positions.

Orient the Top Tube (16) and the Bottom Tube (17) so that the largest holes are on top (see the right inset drawing), and insert them into the indicated holes in the Leg Frame (10). Attach each Tube with an M4 x 15mm Screw (58).

Orient the Ankle Brace Tube (18) as shown, and insert it into the Leg Frame (10). Attach the Ankle Brace Tube with two M4 x 15mm Screws (58).

Make sure that the M4 x 15mm Screws

(58) are tightened into the holes in the bot- toms of the Tubes (16, 17, 18).

12.Set the Foot Plate (19) on the Top Tube (16) and the Bottom Tube (17). Finger tighten four M4 x 25mm Screws (60) through the Tubes into the Foot Plate. Do not tighten the

Screws yet.

11

Largest holes

 

 

must be on top

16

17

18

16

 

 

 

 

17

 

 

 

10

 

18

 

 

 

 

Holes

 

 

Holes

 

 

16

 

 

 

 

58

 

 

17

 

 

 

 

58

58

 

 

 

12

 

 

 

 

19

 

 

 

16

 

 

 

60

 

 

 

 

17

 

 

 

60

 

10

 

 

 

Image 10
Contents Call TOLL-FREE QUESTIONS?Model No. RBBE2057.0 Serial No Mon.-Fri a.m.-6 p.m. MST Sat a.m.-4 p.m. MSTTable of Contents Important Precautions Assembled Dimensions Before YOU BeginPart Identification Chart Before beginning assembly, make sure AssemblyMake Assembly Easier Repeat this step for the Right BasePage See the inset drawing. Identify the Center Frame Page Screws yet Attach the other Front Ankle Brace 22 in the same way Page Page Adjusting the LEG Frame AdjustmentSelecting the Backrest Frame POSI- Tion Leveling the Inversion Table Using the Ankle LockSetting the Inversion Angle Locking the Inversion TableRotating on the Inversion Table Do not sit up to return to the starting positionFull Inversion Program Developing a ProgramBeginner Program Do not attempt to do sit-upsPart LIST-Model No. RBBE2057.0 Qty DescriptionExploded DRAWING-Model No. RBBE2057.0 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT