ASSEMBLY
Make Assembly Easier
This manual is designed to ensure that the inversion table can be assembled successfully by almost anyone. However, the inversion table has many parts, and the assembly process will take time. Most people find that if they set aside plenty of time, assembly goes smoothly.
Before beginning assembly, carefully read the following information and instructions:
•To hire an authorized service technician to assemble the weight bench, call
•Assembly requires two persons.
•Because of its weight and size, the inversion table should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the inversion table as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•As you assemble the inversion table, make sure that all parts are oriented as shown in the draw- ings.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•The included grease and the following tools (not included) may be required for assembly:
Two adjustable wrenches
One rubber mallet
One standard screwdriver
One Phillips screwdriver
Assembly may be more convenient if you have a socket set, a set of
1. | 1 |
Before beginning assembly, make sure | |
that you understand the information in | 2 |
| |
the box above. For help identifying |
|
small parts, see page 5. | 1 |
| |
Press a 63mm Round Cap (40) onto the Left |
|
Base (1). |
|
Attach a Foot (42) to the Left Base (1) with an |
|
M4 x 20mm Screw (71). Next, tighten a | 42 |
Leveling Foot (41) into the Left Base. | 71 |
| |
Repeat this step for the Right Base (2). | 40 |
| |
| 41 |
6