Reebok Fitness RBEX3976.1 manual Seat Bracket, Be careful to avoid pinching and damaging

9. Push the seat handle down. Pull the Seat Carriage	9
(41) towards the back of the exercise cycle until it
stops. Then, pull up on the seat handle to lock the Seat	Avoid pinching and
Carriage in place.	damaging the wires.
While another person holds the Seat Bracket (11) near
the Seat Carriage (41), connect the Right Controller
Wire (82), which has a tag attached, to the wire on the
Rear Wire Harness (51) that has a tag attached. Then,
connect the Left Controller Wire (61) to the other wire
on the Rear Wire Harness. Make sure that the con-				77
nectors on the Controller Wires (61, 82) are posi-
tioned side by side under the plastic cover on the				55
				Plastic
Seat Bracket.	11		61	Cover
Be careful to avoid pinching and damaging the	77	55	82	Seat
			41	Handle
wires. Attach the Seat Bracket (11) to the Seat				51
Carriage (41) with four M8 x 19mm Button Screws (77)
and four M8 Split Washers (55).
10. Identify the Left Pedal (22), which is marked with an	10
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank
Arm (24). Tighten the Right Pedal (not shown) clock-
wise into the Right Crank Arm (not shown). Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten	25
the Pedals.	22
Adjust the Left Pedal Strap (25) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (22). Adjust the Right
Pedal Strap (not shown) in the same way.	24

11.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.

7