Horizon Fitness S400 manual Open Hardware BAG, Attach Cover to bolted joint using 4 Screws F

INTRODUCTION

IMPORTANT PRECAUTIONS

A S S E M B LY STEP 2

HARDWARE BAG 1 CONTENTS :

BOLT (A)	FLAT WASHER (B)	NYLON NUT (C)
Qty: 4	Qty: 12	Qty: 6
BOLT (D)	SUPPORT PLATE
Qty: 2	Qty: 2

A S S E M B LY STEP 3				INTRODUCTION
HARDWARE BAG 2 CONTENTS :
BOLT (A)	FLAT WASHER (B)	NYLON NUT (C)		SCREW (F)
Qty: 2	Qty: 4	Qty: 2		Qty: 4
				IMPORTANT
			SCREW (F)	PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

CONDITIONING

GUIDELINES

TROUBLESHOOTING & MAINTENANCE

WARRANTY
LIMITED
	

	UPPER PULLEY ASSEMBLY
	FLAT WASHER (B)
	NYLON NUT (C)
BOLT (D)
FLAT WASHER (B)
LAT BAR
BRACKET ASSEMBLY
FLAT WASHER (B)	FLAT WASHER (B)
	BOLT (A)
NYLON NUT (C)
	SUPPORT
	PLATE

AOpen HARDWARE BAG 1.

BAttach upper PULLEY assembly to CENTER SUPPORT FRAME using 2 bolts (D), 4 flat washers

(B)and 2 NYLON nuts (C). Tighten this hardware.

CPosition LAT BAR BRACKET ASSEMBLY in line with the

UPPER PULLEY ASSEMBLY and the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown. Using 4 BOLTS (A), 8 FLAT WASHERS

(B)and 4 NYLON NUTS (C) attach SUPPORT PLATES, LAT BAR BRACKET ASSEMBLY and UPPER PULLEY ASSEMBLY to the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown.

	BACK COVER
	FLAT WASHER (B)
FRONT COVER	NYLON NUT (C)	ASSEMBLY

FLAT WASHER (B)
BOLT (A)	RADIAL ARM ASSEMBLY	BEGIN
SEAT WELDMENT SET		BEFORE
		YOU

	STEP 3-D: INSTALLING THE STOPPER:
	RADIAL ARM ASSEMBLY
	STOPPER		CONDITIONING
			GUIDELINES
C	Attach Cover to bolted joint using 4 SCREWS (F).		TROUBLESHOOTING
A	Open HARDWARE BAG 2.		MAINTENANCE &
B Attach SEAT WELDMENT SET.
D Remove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of
	RADIAL ARM ASSMBLY.
E Attach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT			WARRANTY
	WASHERS (B) and 2 NYLON NUTS (C).		LIMITED
		

S400_US_1.1.indd 8-9 8/31/07 10:10:27 AM