Trouble Shooting Guide
Symptom | Possible Cause | Solution | |
|
|
| |
| DC adapter is not plugged into | Plug DC adapter into wall outlet | |
| wall outlet? | ||
|
| ||
|
|
| |
| DC adapter cord is not | Plug DC adapter cord into CDT power socket | |
Console has no power | plugged into CDT? | ||
| |||
|
|
| |
| Console cable is not | Verify that console cable is connected properly | |
| connected? | ||
|
| ||
|
|
| |
| The computer is faulty? | Call the Ironman Fitness service number | |
|
|
| |
|
| Check that the sensor magnet is correctly fitted and | |
|
| passes in front of the sensor | |
|
|
| |
| Computer isn't receiving a | Check that the gap between sensor and the magnet | |
| is 3mm or less | ||
| signal from the sensor? | ||
Strides/Min or Speed |
| ||
Check that all the computer plugs and sockets are | |||
| |||
shows 0 |
| ||
| correctly and firmly connected | ||
|
| ||
|
|
| |
|
| Check that the computer wires are not damaged | |
|
|
| |
| The sensor is faulty? | If all above checks are okay, then replace sensor | |
|
|
| |
| The computer is faulty? | Call the Ironman Fitness service number | |
|
|
| |
|
| Check that the pulse plugs are firmly inserted into | |
|
| the sockets | |
|
|
| |
|
| Check to make sure that the batteries in the chest | |
|
| strap are installed correctly | |
|
|
| |
|
| Replace the chest strap batteries | |
|
|
| |
No HR signal or incorrect | Computer is receiving a faint | Check to see if the receiver is properly installed | |
HR signal | or intermittent pulse signal | Check to see if the chest strap is being properly | |
|
| ||
|
| worn by user - if skin is extremely dry, then | |
|
| moisten contact points on chest with water and try | |
|
| again | |
|
|
| |
|
| If problem still exists then call the Ironman Fitness | |
|
| service number | |
|
|
| |
| Symptoms include an |
| |
| unusually loud noise coming | Try reversing the resistance and try again. If this | |
Noise from motor | from the motor, which means | ||
fails, then replace the motor. | |||
| the gears are not meshing | ||
|
| ||
| correctly |
| |
|
|
|
CLEANING/MAINTENANCE -
Your CDT Elliptical has been manufactured to withstand many hours of use with minimal maintenance. It may occasionally require silicone to be sprayed on the moving parts (available at most stores).
Periodically wipe down your machine with mild, soapy water or a diluted general purpose household cleaner. Machine should be wiped down to remove sweat after each use.
19