CycleOps PRO 300PT, Comp 200E manual Console to bracket

Console to bracket

To connect the console to the bracket, slide the console down onto the bracket. Be sure to slide the console completely down onto the bracket to ensure a solid connection between the console and the bracket. Make sure the contact points between the console and bracket remain clean and free from moisture or debris.

Batteries

The console ships with batteries. In the event the batteries need to be replaced over time, follow these simple steps:

1.Remove the back cover with a small philips head screwdriver

2.Remove batteries

3.Replace with fresh AAA batteries, paying attention to properly line up the poles

4.Replace battery door and secure with small philips head screwdriver

Reed Switch

The Comp 200E is equipped with a reed switch locat- ed on the left rear dropout.

This switch picks up the speed and cadence readings from the flywheel. In the event the switch needs to be replaced, follow these steps:

1.Remove the existing reed switch from the frame by peeling it from the inside of the dropout.

2.Detach the switch from the frame wire by depressing the pinch lock and sliding the two connecters apart.

3.Attach the new switch on the inside of the rear, left dropout with the included double stick tape.

4.Slide the connecters together, making sure to align the pinch lock with the locking tooth on the frame wire. Tuck any slack in the cable back inside the stay.

PT Receiver

The Pro 300PT is equipped with a PowerTap receiver on the rear left dropout. This receiver receives the speed, cadence and power data from the PowerTap flywheel. In the event you need to replace the PowerTap receiver, follow these steps:

1.Remove the existing receiver by loosening the plastic screws, paying attention to loosen the square nuts on the inside of the dropout.

2.Detach the receiver from the frame wire by depressing the pinch lock and sliding the two connecters apart.

3.Attach the new receiver to the dropout with the plastic screws and square nuts (PIC).

4.Slide the connecters together, making sure to align the pinch lock with the locking tooth on the frame wire. Tuck any slack in the cable back inside the stay.

IMPORTANT! How To Zero Torque

The torque must be zeroed to ensure that the PowerTap displays the most accurate power information. If the instantaneous power is positive, or nega- tive, the torque needs to be zeroed. These operations must be done with NO tension on the chain or while stationary with NO force being placed on the pedals. Also, the transmission icon must be illuminated.

To zero torque first ensure the transmission icon is showing then press [DOWN ARROW] to move the cursor to [WATTS]. Press [SELECT] to change to [INCH-LBS]. Then hold down [SELCT] again until "0" is shown. Press [SELECT] to return to [WATTS]. The torque value will now read zero.

6