Gold's Gym GGSY2921.0 manual Repeat this step with the Left Upright not, Shown

12.	Slide the Backrest Frame (17) into the slot in the	12
	Seat Frame (19). Rest the Backrest Frame
	against the Upright Base (6).
				6
						19 17
13	Wrap a Medium Nylon Rope (52) around a “V”-					Slot
		13
	Pulley (49) with the ball on the side shown. Note:					89
	Be sure the ball is on the correct end of the
	Rope; it should slide over the bracket holding					48
	the loop. Attach the Pulley to the Pulley Arm						14
	(14) on the Right Upright (9) with an M10 x 60mm		52
	Button Bolt (89), two Pulley Bushings (48), and	Loop						9
	an M10 Nylon Locknut (72).					48
	Repeat this step with the Left Upright (not		Ball	49	72
	shown).
14.	Slide the Upright Cover (34) onto the Upright	14
	Base (6). Tip the Upright Cover forward and press
	down so that the front tabs engage the Left and
	Right Covers (10, 11). Press the back of the
	Upright Cover so that the rear tabs engage the
	Left and Right Covers.			72
	Orient the Left and Right Uprights (8, 9) as
	shown. Slide the Uprights onto the Upright Base					65		81
	(6). Attach the Left Upright to the Right Upright			9
	with an M10 x 215mm Bolt (81), the Upright
	Spacer (65), and an M10 Nylon Locknut (72). Do					104		8
	not tighten the Nylon Locknut yet.
	Attach the Left and Right Uprights (8, 9) to the					74		74
	Upright Base (6) with four M8 x 25mm Button
	Screws (74) and four M8 Split Washers (104).					34		104
	Tighten the M10 Nylon Locknut (72).		Front
15.	Make sure that all parts have been properly tight-		Tabs6
	ened. The use of the remaining parts will be			11				10
	explained in ADJUSTMENTS, beginning on the
	following page.	10