Gold's Gym GGSY2921.0 manual

9.	Lubricate an M10 x 83mm Bolt (92). Attach the	9
	Pivot Bracket (23) to the Base (4) with the Bolt,
	an M10 Nylon Locknut (72), and a Bench Knob			41
	(41).							23
					72			92
10.	Press two 2” Round Inner Caps (56) into the top				4					Lubricate
		10
	and bottom of the Leg Developer (21). Press two				38	Tube
	46mm Round Inner Caps (55) into the top and		60					56
	bottom of the Leg Lever (22).			72					Lubricate
	Attach the Eyebolt (63) to the indicated side of
			55							38
	the Leg Lever (22) with an M8 Zinc Nylon	60
	Locknut (105).		Tube		2221			91
	Lubricate an M10 x 69mm Bolt (91). Attach the									60
	Leg Lever (22) to the Leg Developer (21) with the	38			Hole			56
	Bolt and an M10 Nylon Locknut (72).		105
	Press four 19mm Round Inner Caps (60) into the						60
	tubes on the Leg Developer (21) and the Leg		55	63	38
	Lever (22). Slide four Foam Pads (38) onto the
	tubes.							41	2
	Slide the Leg Developer (21) into the Bench				1
	Frame (2). Align the hole in the Leg Developer
	with a hole in the Front Leg (1). Tighten a Bench
	Knob (41) into the hole in the Leg Developer.	11
11.	Press four 1” Square Inner Caps (57) into the				Round
	ends of the Backrest Frame (17). Attach a Plastic
	Foot (46) to the Backrest Frame with an M4 x				End
	12mm Screw (102).		18				116			57
	Orient the Backrest (18) and Backrest Backing
	(116) as shown. Attach the Backrest and Backrest									46
	Backing to the Backrest Frame (17) with four M6
	Washers (69) and four M6 x 38mm Screws (90).									102
								1769		69
										90
				57	69			69
								90
		9