ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , and a rubber mallet | . |
|
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been
M8 Nylon | M10 Nylon |
| M10 Split |
| Handlebar | M10 |
Locknut | Locknut | Washer | Washer | Washer | ||
M4 x 16mm |
|
|
|
|
|
|
Screw | M6 x 25mm | M8 x 19mm Button |
| M10 x 27mm | Spring Bracket | |
Screw |
| Screw |
| Pedal Bolt | ||
|
| Washer | ||||
|
|
|
|
|
| |
M8 x 45mm Button Bolt |
|
|
| M10 Bolt Set |
| |
M10 x 27mm | M10 x 27mm | M10 x 75mm Carriage Bolt | ||||
Patch Screw | Screw |
|
|
|
1.Identify the Front Stabilizer (10), which has Wheels (22) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two
M10 Nylon Locknuts (33). Make sure that the Front
Stabilizer is turned so the Wheels are not touching the floor.
1 |
|
| 22 |
34 |
|
22 |
|
| 1 |
34 |
|
10 | 33 |
5