MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the elliptical exerciser regularly. Replace any worn parts immedi- ately.
The elliptical exerciser can be wiped clean with a soft cloth and mild detergent. Do not use abrasives or solvents. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
When storing the elliptical exerciser, remove the bat- teries from the console. Keep the elliptical exerciser in a clean, dry location, away from moisture and dust.
CONSOLE TROUBLESHOOTING
If the console does not function properly, the batteries should be replaced. To replace the batteries, see assembly step 4 on page 5.
HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function proper- ly, see step 5 on page 10.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, remove the indicated Screws (62) from both Pedal Disks (8). Pull both Pedal Disks out of the Side Shields (6, 7). Rotate the right Pedal Disk so that you are able to see beneath it.
Remove the indicated Screws (62) from the Right Side Shield (7). Remove the indicated Screws (66) from both Side Shields (6, 7). Lift the Side Shields off the elliptical exerciser.
7 |
|
6 |
|
62 | 66 |
| |
66 |
|
Next, locate the Reed Switch (57). Turn the Flywheel (41) until the Magnet (43) is aligned with the Reed Switch. Loosen, but do not remove, the indicated Screw (66). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Rock the Flywheel forward and back just enough that the Magnet passes the Reed Switch repeatedly. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shields and the pedal disks.
8 | 6 |
|
|
| 7 |
| 8 | 62 |
|
|
41 |
|
|
43 |
| 66 |
| 57 | |
|
|
12