1.Attach the Rear Stabilizer (4) to the Frame (1) with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
2.Hold the Lower Cable (15) and the Lower Wire Harness (65) in the indicated slot in the Frame (1), and insert the Front Stabilizer (3) into the Frame. Make sure that the Front Stabilizer is oriented as shown. Be careful to avoid pinching the Lower Cable and the Lower Wire Harness. Carefully tip the elliptical exerciser onto one side, and attach the Front Stabilizer with two M10 x 25mm Button Screws
(21)and two M10 Split Washers (67). Do not tighten the Button Screws yet.
3.Hold the Console Bracket (26) near the Upright (2), and locate the wire extending from the bottom of the Console Bracket. Carefully pull the upper end of the Upper Wire Harness (55) to remove any slack, and tie the wire around the Upper Wire Harness, as shown in the inset drawing. Carefully pull the wire up through the Console Bracket until the Upper Wire Harness is extending from the top of the Console Bracket. Then, untie the wire and discard it.
Insert the Console Bracket (26) into the Upright (2).
Be careful to avoid pinching the Upper Wire Harness (55). Attach the Console Bracket with four M8 x 25mm Button Screws (51) and four M8 Split Washers (49).
4.The Console (5) requires three “AA” batteries (not included); alkaline batteries are recommended. Insert three batteries into the Console; make sure that the batteries are oriented as shown by the diagram inside of the Console.
1 |
|
|
|
|
|
| 29 |
| 29 1 | 4 |
|
2 |
| 34 | |
|
| ||
15 | 65 |
| |
|
| ||
3 |
| Slot |
|
1 |
|
| |
| 67 |
| |
|
|
| |
3 |
| 21 | Wire |
|
| ||
26 |
| 51 |
|
51 |
| 55 | |
49 | 49 |
| |
51 |
| ||
49 | 55 |
| |
|
| 2 |
|
4 |
|
|
|
5 |
|
| Batteries |
5