Console Cable Metal Bracket | Healthrider HREL2005.0 instruction

5.While another person holds the Console (5) near the Console Bracket (26), insert the console cable into the Console Bracket and down through the Upright

(2). Next, connect the console wire to the Upper Wire Harness (55). Then, connect the ground wire to the Console Bracket with an M4 x 16mm Screw (66). Insert the Wire Harnesses down into the Console Bracket.

Attach the Console (5) to the Console Bracket (26) with three M4 x 16mm Screws (66). Be careful to avoid pinching the cable and the wires.

6.While another person holds the Upright (2) near the Frame (1), connect the Upper Wire Harness (55) to the Lower Wire Harness (65). Next, connect the con- sole cable to the Lower Cable (15) in the following way:

•See drawing A. Pull up on the metal bracket on the Lower Cable (15), and insert the tip of the console cable into the wire clip inside of the metal bracket.

•See drawing B. Firmly pull the console cable and slide it into the metal bracket on the Lower Cable (15) as shown.

•See drawing C. Using pliers, squeeze together the prongs on the upper end of the metal bracket.

Push the excess cable and wire up into the Upright

(2). Set the holes in the front of the Upright over the studs in the Front Stabilizer (3). Be careful to avoid pinching the cables and the wires. Finger tighten two M10 Nylon Locknuts (29) onto the studs.

Carefully tip the elliptical exerciser onto one side, and attach the Upright (2) to the Frame (1) with two M10 x 68mm Carriage Bolts (19) and two M10 Nylon Locknuts. Tighten all four M10 Nylon Locknuts.

See step 2 on page 5. Tighten the M10 x 25mm Button Screws (21).

5			Console		5
		Ground	Console		5
		Ground	Cable
	66	Wire	66
	66
			55	Console
				26 Wire
		66		2
6	2		29
	2		29
	29
	Console		55
	Cable		55
	3	15	65
	3		1
			1
			19
A	Metal	B		C	Console
	Metal				Cable
Bracket		Console
Console		Console
Console			Cable		15
Cable			15		15
	15		15