Assembly

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Nylon		M10 Nylon	M10 Split	Handlebar	M10 Bracket
Locknut (38)–4		Locknut (33)–4	Washer (59)–6	Washer (55)–2	Washer (35)–2
M4 x 16mm
Screw (52)–2	M6 x 20mm Pedal		M6 x 25mm	M8 x 19mm Button
	Screw (63)–4		Screw (7)–1	Screw (56)–2	Plastic
					Washer (77)–4
M8 x 45mm Button Bolt (50)–4				M10 Bolt Set (74)–2
M10 x 27mm		M10 x 27mm	M10 x 75mm Carriage Bolt (34)–4
Patch Screw (40)–2		Button Screw (67)–6

1.Identify the Front Stabilizer (10), which has Wheels (22) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two

M10 Nylon Locknuts (33). Make sure that the Front

Stabilizer is turned so the Wheels are not touching the floor.

1
	22
34
22
	1
34
10	33
	33