Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

In addition to the included hex keys, assembly requires a phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 18. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled.

M8 Split	M8 Large	M10 Split		Small Wave		Wave Washer	M8 Nylon
Washer (74)–7 Washer (17)–4		Washer (67)–8		Washer (90)–2		(85)–2	Locknut (46)–4
M10 Nylon	M4 x 16mm	M4 x 19mm	M5 x 15mm		M8 x 19mm Button		M8 x 25mm Button
Locknut (29)–2	Screw (66)–4	Screw (39)–2		Screw	Screw (22)–4		Screw (57)–3
				(89)–1
M10 x 22mm Button		M8 x 42mm Button				M8 x 46mm Button
Screw (21)–4		Bolt (50)–4				Screw (20)–4
	Bolt Set (27)–2				M10 x 58mm Button Screw (19)–4
		M10 x 105mm Carriage Bolt (34)–2
				5