16.Attach the Long Cable (58) to the Weight Carriage (19) with a 3/8” x 3/4” Bolt (69) and a 3/8” Nylon Locknut (21). Make sure that the Bolt and the Nylon Locknut are tight.
16
58
CABLE ASSEMBLY
17.Using a 3/8” x 3 1/2” Bolt (16), a 3/8” Flat Washer (9), and a 3/8” Nylon Locknut (21), secure a 3 1/2” Pulley (15) and a Cable Trap
(66)to the upper hole in the Press Frame
(17).Make sure that the Cable Trap and the Pulley are oriented as shown.
Hold a 3 1/2” Pulley (15) inside the indicated bracket on the Press Frame (17). Using a 3/8” x 8” Bolt (59), two 3/8” Flat Washers (9), and a 3/8” Nylon Locknut, attach the 3 1/2” Pulley
21
19
17
69
15 66
16
59
9
15
to the Press Frame as shown.
18.Locate the Short Cable (23). Route the Short Cable under the indicated 3 1/2” Pulley (15). Be sure that the end of the Cable with the ball is between the Pulley and the crossbar on the Press Frame (17).
21 | 17 |
9
Bracket
18
17
15 Ball
Crossbar
23
10