SEAT ASSEMBLY
24.Press a 1 1/2” Square Inner Cap (32) into the Seat Frame (36).
Insert the 1/4” x 2” Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4” x 3/4” Screws (18).
Insert the 1/4” x 2” Carriage Bolt (38) into the indicated hole in the Seat Frame (36). Tighten a 1/4” Nylon Locknut (2) with a 1/4” Flat Washer (10) onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4” Flat Washer (10) and the 1/4” x 2” Screw (24).
25.Press a 1 1/2” Square Inner Cap (32) into the Leg Lever (29).
Lubricate the 5/16” x 2 1/4” Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the 5/16” x 2 1/4” Bolt and a 5/16” Nylon Locknut (3). Do not overtighten the Nylon
Locknut. The Leg Lever must pivot freely.
Insert the 3/8” x 2 1/2” Eyebolt (35) into the Leg Lever (29) from the direction shown. Tighten a 3/8” Nylon Locknut (21) with a 3/8” Flat Washer (9) onto the Eyebolt. Note: Be sure the Eyebolt is positioned vertically on the Leg Lever.
26.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16” x
2 3/4” Carriage Bolt (14) and the Seat Knob
(40).
13
24 |
|
|
|
| 13 |
| 38 |
|
| 37 | 32 |
|
| |
|
| 18 |
36 |
|
|
24 | 10 |
|
| 2 | |
|
| |
25 |
| 36 |
|
| |
|
| 3 |
| ||
| 35 | 29 |
|
| |
|
| 9 |
|
| 21 |
|
| 32 |
26 |
|
|
|
| 40 |
|
| 36 |
14 |
|
|
Pin |
|
|
42 |
|
|