Healthrider 831.159710 manual Adjustment, Adding Weights to the Weight Carriage

Page 15

ADJUSTMENT

The instructions below describe how each part of the home gym can be adjusted. Refer to the exercise poster accompanying this manual to see how the home gym should be set up for each exercise. IMPORTANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct starting position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

ADDING WEIGHTS TO THE WEIGHT CARRIAGE

To add resistance to your workout, slide an equal amount of weight (not included) onto each side of the weight tube on the Weight Carriage (19). Make sure that the weights are pushed against the stops and that the amount of weight on each end of the weight tube is the same. Note: Due to the cables and pul- leys, the actual amount of resistance at each exercise station may vary from the amount of weight used. Use the WEIGHT RESISTANCE CHART on page 17 to find the actual amount of resistance at each weight station.

WARNING: Do not place more than 125 pounds on the weight carriage.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION

Attach the Lat Bar (54) to the Long Cable (58) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (not shown) can be attached in the same manner.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE LOW PULLEY STATION

Attach the Lat Bar (54) to the Short Cable (23) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Pulley Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (not shown) can be attached in the same manner.

19

Weight

Tube

Stops

53

58

52

54

23

53

52

54

15

Image 15
Contents SEARS, Roebuck and CO. Hoffman ESTATES, IL Model No Serial NoFull 90 DAY Warranty Table of ContentsImportant Precautions Before YOU Begin DimensionsAssembly Chart located in the center of this manualFollowing Tools not Included are Required for Assembly Refer to drawing 2b. Align the hole Tighten the Nylon Locknuts yetTighten all Nylon Locknuts used in steps Through Assembly Cable Assembly Cable Assembly Bracket Ball Crossbar From other side Inset shows viewSeat Assembly Locknut. The Leg Lever must pivot freely Seat Assembly Adding Weights to the Weight Carriage AdjustmentAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationEyebolt is positioned vertically on the Leg Lever LEG Lever Weight Resistance ChartWeight on Press ARM Butterfly ARM LOW Pulley High Pulley LbsTightening the Cables TROUBLE-SHOOTING and MaintenanceCable Diagram Long Cable 58 TOP ViewShort Cable 831.159710 R0801A Page Page Qty Description Part LIST-Model NoExploded DRAWING-Model No SEARS, Roebuck and CO., Hoffman ESTATES, IL Model No