CABLE ASSEMBLY
19. Slide a Cable Trap (66) and a 3 1/2” Pulley | 19 |
| 66 |
(15) onto each 3/8” x 3 3/4” Bolt (68). Insert |
| ||
42 |
| ||
the Bolts into the Front Upright (42) from the |
|
| |
|
| 68 | |
direction shown. Hand tighten a 3/8” Nylon |
|
| |
| 15 |
| |
Locknut (21) with a 3/8” Flat Washer (9) onto |
|
| |
| 9 |
| |
each Bolt. Be sure that all parts are orient- |
|
| |
|
|
| |
ed as shown. Do not tighten the Nylon |
|
|
|
Locknuts yet. |
|
| 15 |
|
|
| |
| 21 |
|
|
20. Route the Short Cable (23) around the 3 1/2” | 20 |
| 42 |
Pulley (15) attached to the lower hole in the |
| ||
|
| ||
42 |
| 15 | |
Front Upright (42). See the inset drawing. |
| ||
Be sure that the Cable Trap (66) is turned | 15 |
| 68 |
to hold the Cable in place and that the |
| ||
|
|
| |
Cable is routed around the Pulley as | 21 |
|
|
shown. Tighten the 3/8” Nylon Locknut (21) |
| 66 | |
|
| ||
and the 3/8” x 3 3/4” Bolt (68). |
| 23 | 23 |
|
| ||
|
|
| Inset shows view |
|
|
| from other side |
21. Route the Short Cable (23) up around the | 21 |
| 42 |
3 1/2” Pulley (15) attached to the upper hole |
| ||
|
| ||
in the Press Frame (17). Be sure that the |
|
| 15 |
Cable Trap (66) is turned to hold the Cable |
|
|
|
in place and that the Cable is routed |
|
|
|
around the Pulley as shown. |
|
|
|
Next, route the Short Cable (23) around the |
|
| 66 |
|
| 23 | |
3 1/2” Pulley (15) attached to the upper hole |
| 42 | |
|
| ||
in the Front Upright (42). Refer to the inset |
|
| Inset shows view |
drawing. Be sure that the Cable Trap (66) |
|
| |
|
| from other side | |
is turned to hold the Cable in place and |
|
| |
|
|
| |
that the Cable is routed around the Pulley |
|
| 23 |
(15) as shown. |
|
| |
|
|
| |
| 15 |
| 15 |
|
| 66 | |
|
|
| |
|
|
| 21 |
|
|
| 17 |
11