4.OPERATING INSTRUCTIONS
Operation
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode.
1)Set dipswitches position to Sound Active or Auto Mode.
Mode | Dipswitches |
Sound Active | 1~10 = Off, switch set to Music |
Auto Mode | 1~10 = Off, switch set to Auto |
2)The unit will react to the low frequencies of music via the internal microphone in Sound Active mode, or the unit will auto change in Auto Mode.
3)Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller. In this mode, the first unit in the daisy chain will automatically command all other units following.
1.Connect all LEDsplash™ 152B units in a daisy chain fashion as described in the section following.
2.Dipswitch settings on slave fixtures are not required and will have no effect.
3.Set all dipswitches on the Master unit to the “Off” position and the unit will run its built in color change program.
OPTIONS
-Set Music/Auto switch to Music and for
-Set Music/Auto switch to Auto then use the rotary dial to adjust speed of the program
-See below under DIP switch Options for additional program settings
Dipswitch Functions
FUNCTIONS | DIP SWITCHES ( ON ) | NOTES & DESCRIPTION | |
Color change program |
| Music/Auto switch | |
None | Music: | ||
(Auto/Music) | |||
| Auto: sound adjustment know sets speed of program | ||
|
| ||
| 1 | Low Intensity | |
Red LEDs | 2 | Medium Intensity | |
| 3 | Full Intensity | |
| 4 | Low Intensity | |
Green LEDs | 5 | Medium Intensity | |
| 6 | Full Intensity | |
| 7 | Low Intensity | |
Blue LEDs | 8 | Medium Intensity | |
| 9 | Full Intensity |
LEDsplash™ 152B User Manual | 11 | 3/9/2010 3:02 PM |