Fostex X-12 owner manual Using a tape recorded on a boom box or cassette deck

Page 16

Model X-12 Owner's Manual

Play back the tape on the X-12.

While monitoring the sound via the headphones, use the playback fader and the playback [PAN] knob of each track to adjust the output level and balance of the tracks.

Gradually raise the headphone volume using the [LINE OUT/PHONES] knob. This knob also adjusts the output level at the X-12's [LINE OUT L, R] jacks. Set the level so that the level meter of the master recorder will respond moderately.

5After finishing the level adjustments, rewind the tape to the "000" point.

6Now you can begin mixdown.

First start recording on the master recorder, then press the [PLAY] button on the X-12 to start playback.

7After mixdown is complete, stop the X-12 and the master recorder.

<Note>

You can position the sound on tracks 1-4 anywhere in stereo image on mixdown.

This is where your creatively is important. Try for a sound that is pleasing to you!

Using a tape recorded on a boom box or cassette deck

You can record your favorite music on a boom box or cassette deck and overdub your performance or vocal, accompanying your musician's performance to make your own original tape. Follow the procedure below to make this type of tape.

1. Record your favorite music source on the boom box or cassette deck.

<NOTE>

Be sure to record on only one side of the tape (side A or B).

That is, use Track 1 and 2 to record on the jam box or the cassette deck, and keep Tracks 3 and 4 empty. (See the diagram below.)

Track 4

Track 3

Track 2 (R channel)

Track 1 (L channel)

Do not record now. Later, you will record your performance or vocal here on the X-12.

Record your favorite song to Tracks 1 and 2 on the boom box or cassette deck.

2.Insert the recorded tape in the X-12, and follow the "Overdubbing" procedure described previously to record your performance or vocal to Tracks 3 and 4.

<NOTE>

Note that the law prohibits recording copyrighted or broadcast music, except for recordings intended only for personal use.

16

Image 16
Contents Model Safety Instructions Table of Contents Using write-protection tabs Before UsingCassette tape suitable for recording Important Lets not use it this way Names and Functions AC adaptor connector DC Record track selector REC Track Power switch PowerRecord track select indicator Counter / Reset button ResetRecord indicator REC Power indicator PowerPlayback level fader 1 Playback Panpot knob PANAC outlet Basic Operation recordingPress the Play button to forward the tape for a few seconds Put X-12 in the record standby mode For optimum gain, adjust the LINE-MIC knob CW toward MICTry speaking into the mic Basic Operation playback You can play back the recorded TrackAdvanced Operation OverdubbingX-12 will enter record pause mode Using the Playback PAN knob Up to the playback start point reset the counter to MixdownUsing a tape recorded on a boom box or cassette deck Troubleshooting MaintenanceSpecifications Block DiagramAccessories option SpecificationsFostex Distributors List in Europe