Power switch Power, Line output jack Line OUT L, R

Model X-12 Owner's Manual

1. AC adaptor connector [DC IN]

5. Record track selector [REC TRACK]

Connect the AC adaptor included in the package.

The recording track can be selected. Only one track can be selected at a time.

Be sure to use the included AC adaptor or an equivalent model. Using an AC adaptor with a different rated voltage or a different plug polarity may cause a fire or damage to the product.

The following figure indicates that the output voltage of the AC adaptor is DC (direct current) 12V (volt), that the plug polarity is + (positive) in the center and - (negative) outside. Be sure to use an AC adaptor that complies with this indication.

DC IN 12V

AC outlet

DC IN connector

AC adaptor

2. Power switch [POWER]

Use this switch to turn the power on/off (STANDBY) to the X-12.

When the AC adaptor is plugged into an AC outlet, a very small current flows in the unit even if you turn off (STANDBY) the power switch. If you are not going to use the X-12 for a long period of time, remove the AC adaptor plugged into the AC.

3.Line output jack [LINE OUT L, R]

This jack outputs a signal adjusted by the [LINE OUT/PHONES] knob. Connect this jack to the input jack of a master recorder for mixdown.

4.Record track select indicator

The recording track selected by the [REC TRACK] selector will be indicated in red.

<NOTE>

[REC TRACK] selector does not switch "OFF" the recording track. Since the track to be recorded is always in the selected state, be careful not to accidentally erase a prerecorded sound.

6. Counter / Reset button [RESET]

The counter indicates the tape count. Pressing the [RESET] button will reset the counter to "000."

7.Line out / Headphone level knob

[LINE OUT/PHONES]

This knob enables you to adjust the output level at the [LINE OUT L, R] jacks and the

[PHONES] jack.

8.Cassette lid / Cassette tray

Insert a cassette tape here.

9. Level meter

This meter indicates the input level.

10. Transport control buttons

Record button [REC]

Press the button after you select a track using the [REC TRACK] selector.

The [PLAY] button will be automatically pressed, and the unit will enter the recording mode. This button is disabled if the cassette tape in the tray has a broken or removed write- protection tab.

Pause button [PAUSE]

To resume playback or recording, press this button again.

Stop button [STOP]

Press this button to stop tape transport.

Fast Forward button [F F]

Press this button to fast forward the tape.

Rewind button [REW]

Press this button to rewind the tape.

Play button [PLAY]

Press this button to playback the tape.

When you press the [REC] button, this button will be automatically engaged and the unit will enter recording mode.