allows you to keep track of your actual rid- ing time. The timer only operates when the wheel is rotating and cannot be turned on or off man- ually.
The TM selection is just like a conventional stopwatch. The timer is activated manually and records the time whether the wheel is rotating or not. Tapping the “FUNCTION” button starts and stops the stopwatch and holding the “FUNCTION” button for three seconds will reset to stopwatch.
Note: The average speed (AVS) will be calculated differently based upon the selec- tion of ATM or TM. If ATM is selected, the AVS is based upon only riding time. If TM is selected the AVS is based on the total time the stopwatch is turned on or activated.
To select between ATM and TM press and hold the “FUNCTION” and tap the “MODE” button. Either ATM or TM will flash. Press the “MODE” button to select
8
between the two modes and press “FUNC- TION” to return to normal operating mode.
Computer Functions
Speedometer- Speed is always indicated on the top line of the screen. The speed is shown continuously up to 99.9M/h (99.9 Km/h) with a resolution of 0.1 M/h (0.1 Km/h)
Average Speed (AVS)- The average speed is displayed on the lower line of the screen when AVS is shown on the left. The average speed is based upon whether the ATM or the TM mode has been selected, the resolution of the average speed is shown in 0.1M/h or Km/h increments.
+/- Average Speed Indicator- An up or down arrow
displayed in the upper right side of the screen shows whether the cur-
rent speed is above or below the average speed. The arrow is always displayed so you know if you’re maintaining your aver- age speed while in another mode.
Maximum Speed (MXS)- The maximum is displayed on the lower line of the
screen when MXS is shown on the left. The maximum speed is retained in memory and updated when a higher speed is attained.
The maximum speed can be reset by press- ing the “FUNCTION” button for three sec- onds.
Auto
Start/Stop
Timer (ATM)-
The stop watch
function will operate only when there is speed input and records the actual time spent riding. Pressing the “FUNCTION” key for 3 seconds will reset the ATM display to zero.
Timer Mode (TM)- In TM mode the stopwatch func-
tion will operate when the “FUNCTION” button is pressed. The stopwatch will record the total time after the button is pressed regardless of whether there is speed input or not. The average speed (AVS) will be calculat- ed based on the time the timer mode is acti- vated.
Trip Distance (DST)- Trip distance mode will record up to 999.99 miles or kilometers and then roll to zero. The trip distance func- tion can be reset
by pressing the “FUNCTION” but- ton for three sec- onds. The resolu- tion is 0.01 miles
(0.01Kilometers). The trip distance is shown on the lower line of the screen.
9