Specialized Cyclocomputer manual Installing the Battery, See Figure

Page 6

Odometer (ODO)- The odometer will record the total distance traveled up to 99,999 miles or kilometers and then roll to zero. The odometer can be reset by press- ing the “FUNC-

TION” button for three seconds. The total distance is shown on the lower line of the screen.

Programmable Odometer- The odometer digits are user setable. This is convenient for transferring your hard-earned mileage that is usually lost when changing batteries or computers.

Clock- The SpeedZone® Team has two clocks, one digital and one analog. The digital clock is accessed by pressing the “MODE” button for three seconds. There is an option of either 12 hour or 24 hour clock settings and is shown on the lower line of the screen. The analog clock is

10

always displayed in the upper right side of the screen. The minute-hand of the analog clock has twelve segments and can only display time in five minute increments. The hand will not jump to the next segment until the digital clock reaches whole five minute intervals.

Second Wheel Mode- For riders who own more than one bicycle or who fre- quently change tires, the SpeedZone® Team is capable of storing two tire sizes. You can change between the two sized by pressing both the “MODE” and “FUNC- TION” buttons simultaneously for three sec- onds. The second wheel mode indicator will change from 1 to 2. Mileage recorded will be cumulative between the two sizes. (an accessory handlebar mount is available from your Specialized dealer)

Backlight- The backlight feature of your SpeedZone® Team is activated by pressing the “BACKLIGHT” button on the top of the computer. When pressed the backlight will

remain on for 5 seconds. During this time the current-speed display will be frozen, however the SpeedZone® Team will con- tinue to monitor time and distance functions.

Triple Display LCD- The display screen on your SpeedZone® Team can provide three pieces of information simultaneously:

Current Speed (always displayed on the top line of the screen), Current Time (on analog clock),and your choice of one of the follow- ing: Average Speed, Maximum Speed, Current Time (digital clock), Trip Distance or Odometer.

Installing the Battery-

Your SpeedZone® Team Computer comes with the battery installed at the factory. Should you need to replace the battery, push the computer backwards to remove it from the handlebar mount. Before removing the battery make a note of your odometer reading and wheel circumference settings so that you can re-enter them when you restart the computer. Turn the computer over

so the display is facing downward. Use a coin to unthread the battery cap from the computer. Install the battery (model CR2032) with the positive pole (+) facing upward. Carefully thread the battery cap back onto the case with a coin.

(See Figure 7)

If the LCD display is blank or shows incomplete digits, turn the computer over and press the “AC”

button on the bottom

of the case with thefig.7 tip of a pen or a paper clip. This will clear all the data and re-start the computer.

Reinstall the computer by pushing it forward into the mount until it snaps into place.

The Transmitter battery can be replaced by using a small coin to unthread the battery cap from the transmitter, replacing the bat- tery (model 23A) and carefully threading the battery cap back into place.

11

Image 6
Contents This computer also features What is included in you SpeedZone Team package 2mmMounting the SpeedZone Team Programming Setting Programmable OdometerEasy Calibration Mode Mode.5Timer Mode TM. The ATM selection Generic Tire Size ChartSetting the Clock Roll Out Method+/- Average Speed Indicator- An up or down arrow Auto Start/Stop Timer ATMComputer Functions Installing the Battery See FigureWarranty Information