5.Thread the fan motor cover onto the fan motor assembly threaded nipple and rotate cover clockwise to tighten securely. (Figure 14).
6.Repeat fan motor cover instructions for second fan motor assembly.
| CEILING |
DECORATIVE | CANOPY |
STRAP RING |
|
| UPPER DECORATIVE |
SETSCREW (4) | DOWNROD SLEEVE |
| |
FAN ASSEMBLY | DOWNROD |
| |
STRAP SLOT |
|
| FAN MOTOR |
| ASSEMBLY |
| THREADED NIPPLE |
Figure 14 | FAN MOTOR COVER (1 FOR |
EACH FAN MOTOR ASSEMBLY) |
Figure 15
4.Attach the decorative straps to the upper ring using the flat head screw and nut (provided in the downrod kit), Figure 16.
Final Installation
NOTE: Be careful not to scratch the downrod while moving the sleeve.
DECORATIVE
STRAP RING
FLAT HEAD
SCREW
DECORATIVE
STRAP
CEILING
CANOPY
NUT
UPPER DECORATIVE DOWNROD SLEEVE
DOWNROD
1.Loose the setscrew on the upper decorative downrod sleeve and gently slide it up toward the ceiling canopy (Figure 15).
2.Position the top of the decorative strap ring approximately 1/4” below the knurled nuts on the canopy cover. The strap ring must not make contact with the knurled nuts to allow the fan to freely pivot on the hanger ball. Align the support strap ring so that the slots are in the same position as the slots of the strap supports on the fan assembly below (Figure 15).
3.Tighten the four setscrews in the upper decorative downrod sleeve to secure the decorative strap ring and upper decorative downrod sleeve to the downrod (Figure 15).
Figure 16
5.Assemble the buckle onto the decorative strap (Figure 17).
6.Slide the strap back through the buckle as shown in Figure 17.
7. Position the buckle on the strap as desired.
NOTE: Do not over tighten the straps, the tension should be snug but not over tight.
8.Slide the other end of the decorative strap through the fan assembly strap slot (Figure 17).
9.Assemble the second decorative strap to the other side of strap support on the fan assembly as previously instructed.
10 | U.L. Model No.: CF3300 |
