Toshiba RKP004Z instruction manual Installing the remote keypad to the board optional

2.Installing the LCD remote keypad

2.2Installing the remote keypad to the board (optional)

The remote keypad can be mounted on a board by means of an IP54 attachment (optional).

If an IP65 attachment (optional) is used in combination with an IP54 attachment, the remote keypad can be installed where it may be splashed with water.

Warning

Prohibited

●Never connect the unit to any inverter other than a VF-AS1/PS1 series inverter or any communication device. Do not use any cable other than an optional interconnect cable designed specifically for the unit.

If the correct cable was not used, this might cause the unit to break down and result in an electric shook or fire.

Turn off the inverter, as shown in the figure below.

Tapping screws (4 pieces)

Used to secure the attachment.

Make a hole in the board, as shown in the figure below.

	115
5.5	104	5.5	4-Ф3.5
		5
		100	114.5

IP65 attachment (optional)

Used to be attached to the IP54 attachment

*Leave a space of 45mm or more for the interconnect cable.

IP54 attachment (optional)

Remote keypad

Dedicated interconnect cable (optional) *

*The pin configuration of the dedicated interconnect cable is different from that of any other commercially available cable. Therefore, be sure to use the dedicated interconnect cable.

2-2