5.Operation in Top View Mode
(1)Function of switching between Quick mode and Standard Setting mode <Standard Setting mode selected when power is turned on (parameter PSEL=0)>
•When power is turned on, ”Quick” is displayed. (If the [F1] key is not pressed.) When the unit enters Parameter Setup Mode in this situation, the ordinary top window of Parameter Setup Mode appears.
•If the [F1] key is pressed while “Quick” is displayed, “Quick” is switched from
normal to reverse video “ Quick ”. (If the [F1] key is pressed.)
When the unit enters Parameter Setup Mode in this situation, the Quick mode window appears instead of the top window of Parameter Setup Mode.
<Quick mode selected when power is turned on (parameter PSEL=1)>
•When power is turned on, “ Quick ” is displayed in reverse video. (If the [F1] key is not pressed.)
When the unit enters Parameter Setup Mode in this situation, the Quick mode window appears instead of the top window of Parameter Setup Mode.
• If the [F1] key is pressed when “ Quick ” is displayed in reverse video, “Quick” is switched from reverse to normal video. (If the [F1] key is pressed.)
When the unit enters Parameter Setup Mode in this situation, the ordinary top window of Parameter Setup Mode appears.
<Always Quick mode (parameter PSEL=2)>
•“ Quick ” is displayed in reverse video.
When the unit enters Parameter Setup Mode in this situation, the Quick mode window appears instead of the top window of Parameter Setup Mode.
*In this situation, the [F1] key is inoperative.
(2)Operation Panel and Remote (When used with a VF-AS1 inverter)
•“Panel” is displayed. (If the [F1] key is not pressed.)
In this situation, operation can be performed by remote control by means of the terminal board.
•If the [F1] key is pressed while “Panel” is displayed, “Panel” is switched from normal to reverse video “ Panel ”. (If the [F1] key is pressed.)
In this situation, operation can be performed using keys on the remote keypad. There is no need to switch to Panel Operation mode by changing parameter settings.
*The switching between operation modes cannot be done during operation.
(3)Operation Panel and Remote (When used with a VF-PS1 inverter)
•“Loc/ Rem ” is displayed. (If the [F1] key is not pressed.)
In this situation, operation can be performed by remote control by means of the terminal board.
•If the [F1] key is pressed while “Panel” is displayed, “Loc/ Rem ” is switched from normal to reverse video “ Loc /Rem”. (If the [F1] key is pressed.)
In this situation, operation can be performed using keys on the remote keypad. There is no need to switch to Local Operation mode by changing parameter settings.
*The switching between operation modes cannot be done during operation.
