THIS FAN IS SUITABLE FOR DAMP LOCATIONS
SUCH AS COVERED PORCHES, COVERED PATIOS, AND COVERED
DECKS...ANYWHERE THERE IS A ROOF OVERHEAD.
Tools Needed for Assembly
One Phillips head screwdriver | One stepladder |
One 1/4” blade screwdriver | One wire stripper |
One 5/16” open end wrench or pliers
7/16”, 1/2” & 9/16” wrench or socket wrench One 1/4” drill bit
MATERIALS
Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a
Installed Wire Length | Wire Size A.W.G. |
Up to 50 ft. | 14 |
12 |
WARNING
Before you assemble your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.
Unpacking Instructions
For your convenience,
WARNING
Do not install or use fan if any part is damaged or missing. Call
1-800-654-3545
WARNING
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage.
1.Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
NOTE: Blades and downrod kit sold separately.
a.Fan assembly
b.Two fan motor covers
c.One decorative downrod sleeve
d.One upper decorative downrod sleeve assembly
e.One decorative strap ring
f.One ceiling canopy
g.Four right hand blade flanges
h. Four left hand blade flanges
i.One hanger ball/downrod extension assembly
j.One hanger bracket assembly
k.Eight blade medallions
l.One SW22 wall control with almond and
white knobs | 3 |
|
m.Mounting bracket bag, containing:
1.One 3/8 x 2” lag bolt
2.One 3/8 x 5” lag bolt
3.Two 3/8” flat washers
4.One brass barrel nut
5.One bushing
6.One ceiling support cable
7.One 5/32 x 10mm phillips screw
n.One hardware bag, containing:
1.Five wire connectors
2.One 1/16” hex wrench
3.One clevis pin
4.One hair pin clip
5.Two threaded studs
6.Two lockwashers
7.Two knurled knobs
8.Two
9.One 3/16” hex wrench
o.One flange assembly bag, containing:
1.Seventeen
p.Two blade assembly bags, each containing:
1.
q.One downrod assembly bag, containing:
1.Nine 1/4 x 10mm round head screws
NOTE: Keep all bags unopened until time of assembly. Then place the parts from each loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.
2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the foam pad with the downrod coupling facing up.
The foam pad serves as a holder for the fan during the first stages of assembly.
U.L. Model No.: CF3300