Emerson CF3300ORH, CF3300AP warranty Downrod Extension

DOWNROD

1/4 x 10mm ROUND HEAD SCREW (4)

DOWNROD

EXTENSION

Figure 2

5.Route the motor lead wires and support wire through the decorative downrod sleeve assembly. Carefully slide the decorative downrod sleeve assembly over the downrod and set firmly on downrod coupling (Figure 3).

6.Using the hex wrench (supplied), tighten the three setscrews located at the top of the decorative downrod sleeve assembly (Figure 3).

NOTE: It is important that all setscrews are securely tightened and the decorative downrod sleeve assembly is secure. To not overtighten setscrews.

DOWNROD

SETSCREW (3)

DECORATIVE

DOWNROD SLEEVE

ASSEMBLY

7.Route the motor lead wires and support wire through the upper decorative downrod sleeve and the decorative strap ring (Figure 4). Careful not to scratch the downrod with the sleeve and ring during installation.

NOTE: Be careful not to scratch the downrod during installation.

8.Position the upper decorative downrod sleeve and the decorative strap ring just above the decorative downrod sleeve assembly during initial installation (Figure 4).

DOWNROD

DECORATIVE

STRAP RING

UPPER DECORATIVE

DOWNROD SLEEVE

DOWNROD

SETSCREW (3)

Figure 4

NOTE: Apply masking tape to the entire edge of the ceiling canopy center hole to prevent accidental scratching of downrod surface (Figure 5).

9.Route the motor lead wires and support wire through the ceiling canopy (Figure 5). Use extreme caution not to scratch the downrod with the ceiling canopy during installation.

DOWNROD

CEILING

CANOPY

MASKING

TAPE

Figure 5

NOTE: Be careful not to scratch the downrod during installation.

Figure 3 5 U.L. Model No.: CF3300