Emerson CF3300AP, CF3300ORH warranty Electrical Requirements, How to Hang Your Ceiling Fan

Models: CF3300ORH CF3300AP

1 16
Download 16 pages 42.37 Kb
Page 6
Image 6
Electrical Requirements

10.Route the motor lead wires and support wire through the downrod extension and the hanger ball (Figure 6).

11.Securely attach the downrod to the downrod extension/hanger ball using the four 1/4 x 10mm round head screws (supplied in the downrod assembly bag) (Figure 6). The round head screws must be fully tightened into the downrod extension. A loose downrod will result with fan assembly noise and vibration.

12.Be sure the hanger ball setscrews are securely tighten at this time.

13.The fan comes with blue, black and white leads that are 80-inches long. Before installing the fan, measure up approximately 6 to 9-inches above top of hangerball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

PIN

 

HANGER BALL

 

DOWNROD

SETSCREW

EXTENSION

 

1/4 x 10mm ROUND

HEAD SCREW (4)

DOWNROD

CEILING

CANOPY

Figure 6

How to Hang Your Ceiling FanManual background 14. Downrod assembly is now complete.

Electrical Requirements

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advise, as it must be grounded for safe operation.

The fan hanger bracket assembly shall be supported directly from the supporting building structure. An electrical box is not acceptable for fan support. The building structure must be capable of supporting a load of at least 100 pounds. Consult a qualified professional to determine if your installation meets the structural requirements.

WARNING

To avoid fire or shock, follow all wiring instructions carefully.

Any electrical work not described in these instructions should be done or approved by a licensed electrician.

How to Hang Your Ceiling Fan

IMPORTANT

Do not attach fan blades to fan assembly until the fan assembly is securely installed to the ceiling. Hanging the fan with blades attached may result in damage to the fan blades.

WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 7).

WARNING

Support directly from building structure. Structure must be capable of reliably supporting 100 pounds.

CEILING

AT

LEAST

7'

Figure 7

FLOOR

6

U.L. Model No.: CF3300

Page 6
Image 6
Emerson CF3300AP, CF3300ORH warranty Electrical Requirements, How to Hang Your Ceiling Fan