8.Insert the fan cable through the hole of the large brass barrel nut (supplied) and push it up the cable to within one inch of the small brass bushing. Pass the free end of the cable back through the large brass barrel nut in the opposite direction and remove as much slack as possible.
9.Full tighten the 5/32 phillips head screw on the brass barrel nut to secure the fan cable in position. Cut off and discard the excess fan cable protruding from the brass barrel nut (Figure 9B).
PASS THE FAN CABLE THROUGH THE LOOP AND BACK INTO THE SMALL BARREL BUSHING
FAN
CABLE 
SMALL
BARREL
BUSHING
INSTALL LARGE BRASS BARREL NUT ONTO THE CABLE
FAN CABLE
LARGE BRASS
BARREL NUT
LOOP THE CABLE
BACK INTO THE
LARGE BARREL
NUT
FAN CABLE
LARGE BRASS
BARREL NUT
Figure 9B
Figure 9A
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.
2.Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 10). Securely connect the fan motor black wire to the supply black (hot) wire using wire connector supplied (Figure 15). The blue wire is for optional light kit accessory. Do not connect the blue wire to the supply black wire. Cap the blue wire with a wire connector supplied. After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.
1.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connectors supplied. (Figure 10.)
WARNING
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by
SUPPLY BLACK
GROUND FAN WIRES
WIRE
LISTED
WIRE
CONNECTOR (3)
GREEN WIRE (GROUND) FROM HANGER BRACKET
GREEN WIRE (GROUND) FROM HANGER BALL
Figure 10
NOTE: CEILING COVER
OMITTED FOR CLARITY.
WHITE SUPPLY (NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY (HOT)
THREADED
STUD (2)
Emerson Electric Co. could result in personal injury or property damage.
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
8 | U.L. Model No.: CF3300 |
|
