JVC LVT0954-010A, 0303MWMMDWJEM manual Setting the DVD Player, Selecting the output signal type

English

Setting the DVD Player

You need to set the following, using the setting menu shown on the TV, before starting playback.

•You can select the language used in the setting menu.

•If an Audio CD or MP3 disc is loaded, you cannot show the setting menu. Before starting the setting, remove the disc.

•For further information about the setting menu, see pages 55 to 59.

Step 1: Selecting the On-screen language for the setting menu

Step 2: Selecting the monitor type according to your TV

If audio equipment is connected to the DVD OPTICAL DIGITAL OUT terminal:

Step 3: Selecting the output signal type

If audio equipment is NOT connected to the DVD OPTICAL DIGITAL OUT terminal:

Setting is finished.

On the remote control ONLY:

STANDBY/ON

	1	2	3
				DISPLAY
	4	5	6
				CLOCK/TIMER
	7	8	9
				AP
				SLEEP OFF
	10	0	+10
	ON SCREEN	PLAY MODE	REV. MODE	DVD
		ZOOM	DIGEST	COLOR LEVEL
	AUDIO	SUB TITLE	ANGLE	DIMMER
	TOP MENU		MENU CHOICE
		ENTER
	SET			CANCEL
DVD	DVD	TAPE	FM/AM AUX/MD
	SELECT
SELECT
	STROBE			RETURN
	PREV.	NEXT	SLOW –	SLOW +
	GROUP SKIP
	KEY	DIGITAL
	CONTROL	ECHO	3D PHONIC	AHB PRO
	KEY		FADE	BASS/
	CONTROL	FM MODE	MUTING	TREBLE
SHIFT	SHIFT		VOLUME

RM-SUXA7DVDU REMOTE CONTROL

MENU CHOICE

ENTER

If no operation is done for about five minutes while the setting menu appears on the TV

The screen saver screen (see page 28) automatically appears on the TV instead of the setting menu to prevent the TV screen from being damaged.

To show the setting menu again, press CHOICE while holding down SHIFT.

To select the On-screen language for the setting menu—Step 1:

1 Turn on the TV and select the correct input mode on the TV.

2 Press DVD SELECT 3, then 7.

The unit turns on and the DVD player is selected as the source to play.

The opening screen appears on the TV.

13