JVC 0303MWMMDWJEM manual Changing the Display Illumination, To select the illumination color

Changing the Display Illumination

You can change the illumination color and brightness of the electronic swing panel and the display window.

To select the illumination color

You can set the illumination color to your preference.

Press COLOR (or COLOR/DEMO on the main unit) repeatedly while the unit is turned on until the color you want appears in the main display.

•Each time you press the button, the illumination color changes as follows:

RAINBOW: The rainbow colors illuminate the electronic

To create your favorite colors

You can create two favorite colors and store them in memory as “MANUAL1” and “MANUAL2.”

•There is a time limit in doing the following steps. If the unit exits from the color adjusting mode before you finish, start from step 1 again.

On the remote control ONLY:

1 Press COLOR repeatedly until “MANUAL1” or “MANUAL2” appears in the main display.

The brightness level to be adjusted starts flashing.

English

«

swing panel and the display.

Red Green Blue

GRADATION: The illumination color changes gradually.

«

WATER: A blue-based illumination pattern.

«

FANTASY: Pastel colors illuminate the electronic swing

2 To adjust the brightness of each color

1) Press Cursor 3/2 to select one of the

fundamental colors (Red, Green, Blue) you want

to adjust.

«

panel and the display.

2) Press Cursor 5/∞ repeatedly to adjust the level

CANDLE: A red-based illumination pattern.

of the brightness (within the range of 0 to 3).

«

FOREST:

«

SNOW:

«

SKY:

«

MANUAL1:

«

MANUAL2:

A green-based illumination pattern.

A white-based illumination pattern.

A sky-color based illumination pattern.

The color changes according to the time if the built-in clock is set. If not, “ADJUST! CLOCK” flashes in the main display when you select this illumination color.

You can set the illumination color as you like (see the right column).

	• As you increase the number, the color becomes
	brighter.
	• To restore the initial color for “MANUAL1” or
	“MANUAL2,” press CANCEL.
3)	Repeat steps 1) and 2) to create your favorite
	color.
4)	Press SET.
	Your favorite color is stored.

If you do not make any adjustment for about 8 seconds

«

(back to the beginning)

The normal display resumes and the color you have created up to that time is stored.

More on the illumination color

•The illumination colors cannot always be reproduced precisely. Due to the circumstances (room temperature, etc.) where the unit is used or the setting of DIMMER, colors may vary slightly.

•When you change the illumination color, the display may seem to move back and forth; this is a characteristic of this unit and is not a malfunction.

•When a strong light strikes the unit, it may become dark, but this is not a malfunction.

•While using the unit, the electronic swing panel becomes warm, but this is not a malfunction.

To change the display brightness

Press DIMMER while the unit is turned on.

•Each time you press the button, the display brightness changes as follows:

DIMMER 1: The display illumination dims.

«

DIMMER 2: The illumination color disappears.

«

DIMMER OFF: The display illumination resumes.

• Pressing COLOR (or COLOR/DEMO on the main unit) also

resumes the display brightness.

«

(back to the beginning)

22