JVC LVT0749-003A, CA-NXCDR7R manual Maintenance

Page 58

Maintenance

To get the best performance of the unit, keep your discs and mechanism clean.

General Notes

In general, you will have the best performance by keeping your discs and the mechanism clean.

•Store discs in their cases, and keep them in cabinets or on shelves.

•Keep the disc trays closed when not in use.

To play new discs

New discs may have some rough spots around the inner and outer edges. If such a disc is used, this unit may reject the disc.

To remove these rough spots, rub the edges with a pencil or ballpoint pen, etc.

To handling discs

When removing a disc from its case, press down the center holder of the case and lift the disc out, holding it by the edges.

• Always hold the disc by the edges. Do

not touch its recording surface.

When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up).

• Make sure to store discs into the cases after use.

• Be careful not to scratch the surface

of the disc when placing it back in its case.

• Avoid exposure to direct sunlight, temperature extremes, and moisture.

To clean the disc

Wipe the disc with a soft cloth in a straight line from center to edge.

DO NOT use any solvent—such as conventional record cleaner, spray, thinner, or benzine—to clean the disc.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

•After starting the heater.

•When the unit is moved from the extremely hot place to the extremely cold place.

Should this occur, the unit may malfunction. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates.

• DO NOT expose discs to direct sunlight or any heat source or place them in a place subject to high temperature and humidity.

• DO NOT leave discs in a car.

To clean the unit

• Stains on the unit

Should be wiped off with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in water- diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

•Since the unit may deteriorate in quality, become damaged or get its paint peeled off, be careful about the followings.

—DO NOT wipe it with a hard cloth.

—DO NOT wipe it strong.

—DO NOT wipe it with thinner or benzine.

—DO NOT apply any volatile substance such as insecticides to it.

—DO NOT allow any rubber or plastic to remain in contact with it for a long time.

– 53 –

Page 57 Page 59
Image 58
Page 57 Page 59
Contents CA-NXCDR7R If in Doubt Consult a Competent Electrician Front view Class Laser Product Above ALL Contents Precautions IntroductionImportant notice Precautions on Disc Playback and RecordingRecording Following discs cannot be used for recordingRemote Control Remote ControlLocation of the Buttons and Controls Main Unit Press OPEN/CLOSE e to move down or up the sliding panelMain Unit Display WindowDisplay Window Timer mode indicators 48 Daily 9 REC 0 SleepUnpacking Connecting AntennasGetting Started FM antennaAM MW/LW antenna Connecting SpeakersYou can connect the speakers using the speaker cords To connect an outdoor AM MW/LW antennaTo connect an analog component such as a cassette deck Connecting Other ComponentsTo connect digital components Protective cap Putting the Batteries into the Remote Control Remote sensorBasic and Common Operations Press OPEN/CLOSE to move down or up the sliding panelTo adjust the input level through the Line in jacks Turning On the PowerSaving the Power Consumption while On Standby Selecting the Sources and Starting PlayChanging the Display Information Adjusting the VolumeReinforcing the Bass Sound Selecting the Sound Modes To use your own sound modeTo check the sound mode currently selected, press Creating Your Own Sound Modes -MANUAL ModesListening to FM and AM MW/LW Broadcasts Presetting Stations Tuning into a StationTo change the FM reception mode Tuning into a Preset Station Receiving FM Stations with RDSPress PTY Search again Changing the RDS InformationSearching for Programs by PTY Codes PTY Search To continue searching after the first stopTA News Info TA+News TA+News+Info News+Info TA+Info Switching to a Program of Your Choice AutomaticallyTo activate the EON function, follow the procedure below Unit continues to receive the stationAlarm function Description of the PTY codesPlaying Back Discs on 3-CD Changer 10+10Disc tray closes Loading DiscsPlaying Back the Entire Discs-Continuous Play You can play discs continuouslyPrograming the Playing Order of the Tracks -Program Play To go to another track directly using the number buttonsBasic Disc Operations To start playing a disc during playback of another discPlaying at Random-Random Play To check the program contentsTo modify the program CD1 Play ? To select the Continuous Play mode for 3-CD ChangerOther Convenient Functions CD2 Play ?To cancel the prohibition and unlock the discs To adjust the playback speedOn the remote control only Press Pitch during play To prohibit disc ejection-Disc LockPlaying Back a Disc on CD Recorder CDRRepeating Tracks-Repeat Play On the remote control only Press 0CDRPlaying Back a Disc-Normal Play To locate a particular point in a track during playRecording on a CD-R/CD-RW REC LevelSampling frequency rate converter Optimum Power Control OPCBefore You Start Recording Auto track spaceHigh-Speed Recording Available recording modes-REC ModeFinalization Recording Any Sound Source Standard Recording To fade in and fade out the recordingWhen the source is other than 3-CD Changer To adjust the recording input levelWhen the source is 3-CD Changer To make a silent portion in your recordingCD Direct Recording Using the Direct REC buttonRecording from 3-CD Changer -CD Synchronized Recording On the unit only Prepare discs in 3-CD ChangerCD REC? = 1st Tr. REC? = SET=LISTENING? = Using the REC Mode buttonCD REC ? Select this to perform CD Direct Recording First Track Recording Using the REC Mode button onlyDuring First Track Recording To stop during editing process and start recording, press Listening Edit RecordingRepeat to program other tracks During Listening Edit RecordingRecording starts automatically when the sound signals come Sound SYNC. REC? CanceledREC indicator flashes on the display for a while Start playback on the selected external component1Tr. REC ? Recording a Single Track during PlayFinalizing a Disc-CD-R/CD-RW Press FinalizeOther Convenient CDR Functions MenuAuto Track indicator lights on the display Converter =Canceled =back to the beginningSetting for auto-track marking appears Recording Track Marks Manually -Manual Track-MarkingTurning On or Off Sampling Frequency Rate Converter Current setting for Track Space appearsCurrent setting for Converter appears Separating Recorded Tracks Automatically-Auto-Track SpacePress Enter Erasing Tracks Only for CD-RWPress ¢or 4 to select the erasure start track DisplayYou can erase all the recorded tracks on a CD-RWat a time Erasing All Tracks Only for CD-RWUnfinalizing a Disc Only for CD-RW Confirmation message appearsUsing the Timers To adjust the clock again Setting the ClockUsing Recording Timer How Recording Timer actually worksFM AM Line To turn on or off Recording Timer after its setting is doneTo turn on the Recording Timer, press SET If you have selected FM or AM as the sourceCD CDR Line Using Daily TimerHow Daily Timer actually works AM FMTo turn off the Daily Timer, press Cancel to select Press ¡/ ¢or 4/ 1to adjust the volume level, then press SETDaily Daily Timer indicator stops flashing and remains lit To turn on the Daily Timer, press SETUsing Auto Power Off Using Sleep TimerHow Sleep Timer actually works Maintenance Glossary Messages Troubleshooting Change the position and directionAmplifier SpecificationsFM tuning range MHz 108.00 MHz AM MW/LW tuning range TunerCD player Supplied accessoriesDimensions approx Mm x 210 mm x 349 mm Mass approx CD RecorderJVC 0701MWMMDWJEM

CA-NXCDR7R, LVT0749-003A specifications

The JVC LVT0749-003A CA-NXCDR7R is a versatile audio playback device that offers exceptional sound quality and a host of features specifically designed for music enthusiasts. This compact stereo system combines a sleek design with cutting-edge technology, making it a suitable addition to any home or office environment.

One of the standout features of the CA-NXCDR7R is its CD player that supports various formats, including CD-Rs and CD-RWs. This functionality allows users to enjoy their favorite music, whether it's stored on commercially released CDs or custom-made discs filled with personal playlists. Additionally, the system supports MP3 playback, which means users can listen to audio files that have been compressed to conserve storage space, all while maintaining impressive sound quality.

Equipped with an FM/AM tuner, the JVC CA-NXCDR7R provides access to a wide range of radio stations. The tuner is designed for easy channel scanning, ensuring that users can quickly find their preferred radio broadcasts. The system also features a built-in digital clock with a sleep timer, perfect for individuals who enjoy falling asleep to music.

The JVC CA-NXCDR7R incorporates an auxiliary input, allowing users to connect external devices such as smartphones, tablets, or laptops seamlessly. This expands playback options, enabling users to listen to their favorite streaming services, podcasts, or audio files from various sources. The system also has speaker output terminals, which allow for the connection of external speakers for those who desire improved audio performance.

Another innovative feature of the CA-NXCDR7R is its remote control, offering convenience and ease of use. Users can adjust volume levels, switch tracks, and change settings from a distance, making it a user-friendly option for anyone who wants to enjoy music without having to constantly get up.

Overall, the JVC LVT0749-003A CA-NXCDR7R is a modern audio system that combines high-quality sound with practical features. Its student-friendly design and multiple playback options cater to a wide audience, reinforcing JVC's commitment to delivering exceptional audio experiences in an accessible package.
Top Page Image Contents