Huffy In-Ground Basketball manual Before YOU Start

Page 2

BEFORE YOU START

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.

NOTE: Not all items pictured are included with every model.

HEIGHT

ADJUSTMENT

Rotate crank handle to raise and lower backboard.

Do not over crank

 

handle beyond the

 

manufactured height

 

indicator range of

A

7-1/2 - 10 feet.

 

Damage may be

 

caused to the screw

B

jack’s internal

adjustment

 

mechanism if

 

adjusted over 10 or

 

under 7-1/2 feet.

 

MOVING SYSTEM

1.While holding pole, rotate basketball sytem forward until wheels engage with ground.

33

2.Move basketball system to desired location.

3.Carefully rotate basketball system upright.

4.Check system for stability.

2

3

1

568090 11/06

NOTICE TO ASSEMBLERS

Adult Assembly Required. Dispose of ALL packaging materials promptly. As with all products, periodically inspect

for loose small parts.

Assembled unit MUST be filled with sand or water at ALL times.

ALL basketball systems, including those used for DISPLAYS, MUST be assembled and installed according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift support system.

ID# M6809011

12/06

2

Image 2
Contents Portable System Before YOU Start Safety Instructions Get to know the basic parts of your basketball system Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #30 #36 #13 Fig. a Poles Wood Scrap Not supplied Do not Tighten Struts Must be attached to Base through Larger holes Completed Assembly Section B Attach the Backboard Carefully cut Install Slam Jam Rim to Backboard 12/06 ID# M6809011 ID# M6809011 12/06 If Using Sand 2 Gallons of ANTI-FREEZE is not Required Handle 21 can be removed and stored by removing pin